Control automation and SCADA systems are a vital part of any pneumatic conveying and powder handling projects. Our experience and ability to interpret, design and supply electrical and electronic control panels is an important part of our total system approach to these projects.

We design electrical circuit diagrams for programmable logic controllers (PLC I/O), instrumentation, motors and control panels. Our standard panels include the following:

• IP55 floor standing stainless steel enclosure with finishing epoxy powder coating
• Earth fault relay or earth leakage relay (live protection)
• Electrical power meter (in KWs)
• Form-2B motor starter compartment
• Three phase (AC380V-AC41V5) or single phase (AC200V-AC240V)
• Proper arrangement of terminal block for all equipment on the circuit
• Electrical wiring circuit diagram
• Rigorous factory acceptance testing including phase insulation and earth fault testing

Dependent upon the control automation requirements, we can supply:

• PLC hardware and software
• Recipe management and batch traceability
• Reporting systems
• System Control and Data Acquisition (SCADA)
• Motor control centres
• Choice of hardwired, remote I/O, DeviceNet or ASiBus

We are not limited to these options. Feel free to contact us to see how we can design and supply the specific system you have.